When this occurs, the running belt can no longer absorb lubrication. This is a term used that describes the pores on the underside of the running belt closing due to excess friction.
When lubricating be sure to use a 100% silicone non-aerosol treadmill lubricant, applying 1-oz.Īfter lubricating the running belt, if you still continue to have problems or it returns after just a few weeks, the running belt may have become glazed. The lubrication frequency will vary depending on the model, please refer to the lubrication instructions in the owner's manual. It is important to maintain a proper lubrication schedule for your treadmill. The motor control board will shut down due to the motor pulling too much current, triggering a safety shut down. If the running belt moves for several minutes and then produces the E1 error, this is most commonly a result of the running belt needing lubrication.
Cam350 12 mill erros code#
An E1 code just means that the console is not getting a reading from the reed switch (Speed Sensor). It is important to know when the E1 occurs and what was being done when it occurred. ErrorĪn E1 error code is a very broad code. If after trying the suggested solutions your treadmill is still showing an error please contact our customer service department at 877.654.3837 x4 or fill out a customer service request form.
Please refer to the following treadmill troubleshooting guide if your LifeSpan treadmill or treadmill desk is displaying an error code.